Installation

Tools Required

  1. Clean microfiber towel
  2. Clean regular towel
  3. Alcohol based cleaner or Acetone
  4. 2x4 aprox. 65” long
  5. 4 Wood clamps

 

 

Installation

  1. Clean surface of gate with alcohol-based solution and clean microfiber towel.
  2. Grab a friend
  3. Check alignment
  4. Remove just enough of the tape's plastic so you can grab the tail of it from the front of the panel.
  5. Gently set in place
  6. Press in center and pull the tape's tail out from the center's top and bottom.
  7. Continue to press firmly in the center for 1 minute.
  8. Open the tailgate and remove the tape's tail on the left and right side. 
  9. Wrap the 2x4 in the towel, open the tailgate, place the 2x4 across the panel and clamp each side down. *****We recommend leaving clamped overnight, but at minimum for at least an hour. Full adhesion is achieved at 72 hours.

 

  1. With 2 clamps per side, clamp the top and bottom corners. *****We recommend leaving clamped overnight, but at minimum for at least an hour. Full adhesion is achieved at 72 hours.
  2. Remove clamps and ride on!